News:

Please let me know of any errors or suggestions to improve the site
(either email or use the "Contact Us" on the main site).

Main Menu

Engine Well

Started by Old Forum, April 08, 2014, 06:46:51 AM

Previous topic - Next topic

Old Forum

Martin Cartwright
   
Posted on Tuesday, June 05, 2007 - 09:22 am:      
In some conditions I get quite a large amount of water sloshing up from the engine well. I have made floor boards to keep my feet dry, and when at sea, I remove the engine and seal off the well. However I would be very interested to hear if anyone has managed to reduce the aperture with the engine in place. Any pictures would be interesting.

Old Forum

Roger Parish
   
Posted on Tuesday, June 05, 2007 - 04:58 pm:      
I leave split boards in position all the time as it eliminates any turbulence in the well which must have some beneficial effect on performance. This is mentioned on my website. The boards are held in place with a bungy rope around the engine. They are easily removed from the cockpit if you have to take the engine out. The edges of each board have a small wood lip to help location and the rear edge has a stainless clip which locates over the lip of the well and the front edge has a stainless strap or lacing eye through which you can attach the hook of the bungy rope. Best to leave a little clearance around engine leg to stop any vibration.

Old Forum


Roger Parish
   
Posted on Tuesday, June 05, 2007 - 05:14 pm:      
Here is another picture from the inside. Better than all those words!

Old Forum


Martin Cartwright
   
Posted on Wednesday, June 06, 2007 - 08:09 am:      
Thanks Roger. I will give this a try.